Verex Monitor ISM Spezifikationen PDF herunterladen (Seite 15)

22-9058 v2.1

Welcome

PCPanel IP

Cent. Mon. with IP

Ref. Topics

2.3.1 Setting the IP Module Director Parameters

For main panel to Communicate with the Director Software

• Press the “ISM” tab on the left side of the config screen.

• The default settings will enable an immediate connection to the Director software system.

Modifications to these settings are only necessary to:

• Use the Firewall feature.

• Change the UDP (Local Port).

• Use the Remote IP features.

The selections are:

Setup

Mode

(Firewall specifics)

Default: “No Firewall”

• Disabled No communications with the Director software.

• No Firewall

Ordinary communications with Director software and no restrictions on the Director’s IP

address.

• Firewall

Communications with the Director is limited to the addresses specified in the Firewall

settings.

Local Port (UDP Port number of IP module for Director communications)

Default: “24822”

• The value entered here must also be entered into Director/System/Communication/Host Connection

“Interface IP Port” field for the appropriate panel(s).

Remote IP (The IP address of ISM Director communications client)

Default: “0.0.0.0”

• Each “0” is changed to the series of numbers separated by decimals in the IP address of the Director

PC if it is required that the main control board initiates an IP connection to the Director software.

• “Connection Type” in Director/System/Communication/Host Connection/Connection type: is set to

“Allow Incoming and Outgoing IP Calls”.

• The IP address entered must match the IP address of the PC running the ISM Director

communications client.

...continues...

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Keine Kommentare

Verex Monitor ISM Spezifikationen Seite 15